TVVBPG-TV elevator specific flat cable_安徽中盛电气集团有限公司官方网站

加入购物车成功！

产品名称：TVVBPG-TV elevator specific flat cable
浏览：
添加时间：2024-08-07 15:49:21
推荐度：

介绍：

TVVBPG-TV 电梯专用屏蔽射频网络随行电梯专用扁电缆导体超柔性软导体，特软抗衰减绝缘，屏蔽层密度100%，护套柔软耐磨抗拉抗撕裂，外加镀锌加强型钢丝。 TVVBPG-TV 电梯专用屏蔽射频网络随行电梯专用扁电缆的特性是保持电梯在运行过程中电缆来回移动，

TVVBPG-TV elevator specific shielded RF network accompanying elevator specific flat cable conductor ultra flexible soft conductor, specially soft and anti attenuation insulation, shielding layer density of 100%, sheath soft, wear-resistant, tensile and tear resistant, externally reinforced with galvanized steel wire. The characteristic of TVVBPG-TV elevator specific shielded RF network accompanying elevator specific flat cable is to keep the cable moving back and forth during the operation of the elevator,

TVVBPG-TV 电梯专用屏蔽射频网络随行电梯专用扁电缆导体超柔性软导体，特软抗衰减绝缘，屏蔽层密度100%，护套柔软耐磨抗拉抗撕裂，外加镀锌加强型钢丝。 TVVBPG-TV 电梯专用屏蔽射频网络随行电梯专用扁电缆的特性是保持电梯在运行过程中电缆来回移动，弯曲，网线负担重力的情况下，能很好的保持良好的通信效果。

TVVBPG-TV elevator specific shielded RF network accompanying elevator specific flat cable conductor ultra flexible soft conductor, specially soft and anti attenuation insulation, shielding layer density of 100%, sheath soft, wear-resistant, tensile and tear resistant, externally reinforced with galvanized steel wire. The characteristic of TVVBPG-TV elevator specific shielded RF network and accompanying elevator specific flat cable is to maintain good communication effect while keeping the cable moving back and forth, bending, and the network cable bearing gravity during the operation of the elevator.

一、适用范围

1、 Scope of application

TVVBPG 本产品适用于交流额定电压300/500V（或450/750V）及以下电梯和升降机械设备等，作电源动力连接线用。

TVVBPG is suitable for elevators and lifting machinery equipment with AC rated voltage of 300/500V (or 450/750V) and below, as a power connection line.

二、执行标准

2、 Execution standards

QB/WB2008-6及补充要求

QB/WB2008-6 and Supplementary Requirements

三、使用特性

3、 Usage characteristics

1、电缆导体的长期允许工作温度不超过120℃，敷设环境温度应不低于0℃。

1. The long-term allowable working temperature of cable conductors should not exceed 120 ℃, and the laying environment temperature should not be lower than 0 ℃.

2、安装自由悬挂长度不超过80m，移动速度不超过4m/s。

2. Install a free suspension with a length not exceeding 80m and a moving speed not exceeding 4m/s.

3、电缆敷设安装允许弯曲半径应不小于电缆小边的6倍。

3. The allowable bending radius for cable laying and installation should not be less than 6 times the small edge of the cable.